Diagnostic Trouble Codes

Random Picture

Links Directory

Home

Articles & Guides

Diagnostic Codes

Diagnostic Trouble Codes - 1995 Mazda

Welcome to Iron Piston - Toronto Car Forums! The new, passionate and one of the fastest growing automotive communities. We help bringing together car clubs, car shows and street car enthusiasts from Greater Toronto Area. Find great performance shops and repair garages near you and check out some hot street racing videos. Getting help with your engine & suspension mods and sharing your talent is just a step away. Support Toronto's car and racing community by registering today.

Featured Toronto Car Forums
[Member Introductions] [General Car Talk] [Engine & Drivetrain Help] [Forced Induction & Exhaust] [Toronto Classifieds]

Diagnostic Trouble Codes - 1995 Mazda

Written by Genesis

Sunday, 14 February 2010 10:39

Share your experience and get help from other Mazda owners in our Forums

02 Crank Position Sensor (NE Signal).
03 Cam Position Sensor (SGC Signal).
05 Knock Sensor.
08 Air Flow Sensor.
09 Engine Coolant Temperature Sensor.
10 Intake Air Temp. Sensor (Air Flow Sensor).
12 Throttle Position Sensor.
14 Barometric Absolute Press. Sensor.
15
and/or
23 Heated Oxygen Sensor (Inactivation).
16 EGR Function Sensor.
25 Pressure Regulator Control Solenoid Valve.
26 Purge Control Solenoid Valve.
28 EGR Vacuum Solenoid Valve.
29 EGR Vent Solenoid Valve.
34 Idle Air Control Valve.
41 VRIS 1 Solenoid Valve.
46 VRIS 2 Solenoid Valve.

To Extract DTCs:

1. Warm engine to operating temperature and turn ignition "OFF."
2. Install jumper wire between TEN and GND terminals of data link connector.
3. Turn the ignition switch to the ON position.
4. If MIL illuminates for 3 seconds, goes off, and stays off, no codes are present.
5. If MIL illuminates, then starts flashing, record codes.
6. When all codes have been recorded, remove jumper wire.

Discuss in the forums